Bolt-On Hardtail Section For 1963 to 1970 Triumph Motorcycle

Many motorcycles look much better with the simple lines provided by a rear rigid frame. Lowbro Customs hardtail section will setup your custom Triumph about 2” lower and with a 4” stretch wheelbase over stock. This hardtail section features 1.25” tubing and 5/16” thick axle plates and. It can be bolt-on directly to 1963-1970 factory Triumph frames. Very affordably priced at $249.95, in stock and made in Cleveland, Ohio. More info at 1-855-456-9276 or visit

7 Responses to “Bolt-On Hardtail Section For 1963 to 1970 Triumph Motorcycle”

  1. 1 rcupp Aug 14th, 2017 at 4:03 am

    Huh, That’s swell…clean and easy!!

  2. 2 Sam Aug 14th, 2017 at 9:06 am


  3. 3 Aug 14th, 2017 at 9:52 am

    Exactly the the one designed and built by Corbin Gentry in 1970

  4. 4 domino Aug 14th, 2017 at 1:16 pm

    Reminds me of the one I used in ’75 when I built my ’59 (pre-unit) Triumph chop … Of course I welded the bolt on hardtail and molded it …
    …………………………… Domino Dave ……………………………..

  5. 5 Sheridan Aug 14th, 2017 at 7:23 pm

    Love the way the Triumph frames were two halves, so you can just bolt on your hardtail and be on your way, and swap it back if you need to. Got a project just like this on the go myself right now.

    I think Indian could learn a think or two by looking at that roller. The key to a good looking bike is a good looking frame to start with as a base.

  6. 6 hacksaw Aug 18th, 2017 at 10:07 pm


  1. 1 Trackback on Aug 16th, 2017 at 9:57 pm
Comments are currently closed.